One of them were not compatible with FSX. dll in your main fsx folder to load and it does not belong to the default installation, then that caused the crash. What were you doing when FSX stalls and stops working? If you allowed the dll.xml and exe.xml to load and/or any non-default. I still have the same problem, sfter about 10-20 minutes fsx stalls and stops working. Or you could completely uninstall per the link I provided above and reinstall your FSX Gold disks. I would also run a registry cleaner to make sure the registry is cleaned too. Make sure you remove all of the hidden folders. If it doesn't then your repair was not completed properly and you would be best served to uninstall FSX/Acceleration and buy FSX-SE for less than $5 (until the 26th) and install. When you first start up FSX after a repair, it will go through all of the normal actions as if you just installed FSX like asking you if you trust this module or that module. They are installed when you install FSDT airports and other addons that require the use of of these. It is added when you install an addon like FSUIPC.
The Modules folder will be replaced as that is normally not installed when you install FSX/Acceleration. It will overwrite your fsx.cfg and your scenery.cfg. What will 'repair' do? It will replace GEX textures that replaced your default textures but not FS Dreamteam or UTX. Repair goes through all of the actions as if you are installing FSX for the first time. If this does not happen, then you have something seriously wrong with the fsx disks. Once the second disk has completed, insert the third disk (Acceleration) and chose 'repair'. When the first disk has done its thing, it will ask for the second disk.
You insert the first disk and chose 'repair'.
So Jim what are the exact steps cause I chose repair on the first disc, then rebooted and then did repair on fsx acceleration disc I believe, but many of my addons are still there like from fs dreamteam GEX, UTX, etc, but I still have the same problem, sfter about 10-20 minutes fsx stalls and stops working.
0 kommentar(er)
